Section modeler brep error

Please takea look at the file. the given brep does not generate properly. the grillage is only in one direction and it is even broken. Thankyou in advance.

Attachments:

Replies to This Discussion

Permalink Reply by Erick Katzenstein on November 21, 2011 at 12:18pm

I think the offset was exploded the section curves. I plugged a "SimplifyCrv" into the definition, so try the attached one.

Attachments:

SectionModeler_Updated[autosave].gh, 267 KB

Permalink Reply by Huzefa Ali on November 21, 2011 at 4:50pm

Thank for the reply Eric,but it is still not working. Did you try it with the rhino attatched file? Did it work? It gives different broken geometries at different slider values.

Permalink Reply by Erick Katzenstein on November 22, 2011 at 7:29am

Try changing Thickness to .172 and Width to .5 (I think these were your original settings). It will take a while to update. Let me know if that works.

Permalink Reply by Huzefa Ali on December 5, 2011 at 7:23pm

still not working.

Permalink Reply by Huzefa Ali on December 5, 2011 at 7:22pm

not working. Have to make the model till friday. It worked fine before, but once the form got little more complex it has stopped working. you can take a look at my last model here.

http://www.grasshopper3d.com/photo/dsc02652?xg_source=activity

RSS