Grasshopper

algorithmic modeling for Rhino

Plane surface

Hi,

I have a question regarding PlaneSrf(Surface) creation.

So my problem is that the basepoint (P) of the PlaneSrf is in the corner and not in the centre of gravity.

When I use the Move component to be in centre and connect with Sweep1, Sweep1 ignore everything. When I delete the Move component Sweep1 works well.

any idea?

Views: 2271

Replies to This Discussion

Permalink Reply by Hannes Löschke on December 4, 2013 at 9:25am

Could you please post the definition, from what you describe, you got the whole concept of PlaneSrf and Sweep1 confused.

For a PlaneSrf you need to provide the X and Y dimensions as Domains (From... To). If you just input single numbers, they will be interpreted as "From 0.0 to your number". That's probably, why your basepoint is at the corner.

Sweep1 requires curves as input. Neither Points, Planes or Surfaces will work.

Permalink Reply by Onrender on December 5, 2013 at 6:30am

Hi! Thanks! Actually Domains do more than I expected. Now works well correctly. Thanks again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service