Who can make scherk second surface

Replies to This Discussion

Permalink Reply by Liumo on October 10, 2013 at 7:45am

Thank you despite I don't get all of your ideas.

According to Wikipedia, sin(z)-sinh(x)*sin(y)=0 is the implicit equation

I don't know if the equations I posted is the real parametric equations of the surface.

 

 So you think that the the parametric equations are better than implicit equation, right?

Permalink Reply by Vicente Soler on October 10, 2013 at 8:34am

This particular set of parametric equations aren't as useful to fit a nurbs surface through them. It's still better than trying to generate an isosurface from the implicit equation. I had to cheat a bit to not overcomplicate things, see attached:

You'll need Meshedit, which is the plug-in you are asking for below.

Attachments:

• scherk.gh, 14 KB

Permalink Reply by David Stasiuk on October 10, 2013 at 8:42am

super!

Permalink Reply by Liumo on October 10, 2013 at 12:53pm

wow!super!

Thank you.

It is a new way to solve this problem

Permalink Reply by Vicente Soler on October 10, 2013 at 5:22pm

because there are not enough pictures of subdiv meshes with holes on this forum yet.

Permalink Reply by federico caputo on February 19, 2017 at 3:57am

Great algorithm!

Could you explain ho to stack more Scherk's sencond surfaces into a taller pile? thank you

Permalink Reply by Liumo on October 9, 2013 at 5:10pm

Which plug-in has these two component?

Permalink Reply by Michael Pryor on October 10, 2013 at 9:20am

UTO mesh analysis and utility

• ‹ Previous
• 1
• 2
• Next ›
• Page