Grasshopper

algorithmic modeling for Rhino

Loft multiple closed curves

Hi,

I am trying to get an correct surface creating with the following curves, eventually with a gap in the middle, but, at the moment, I am not able to loft the curves correctly.

Views: 4207

Attachments:

Replies to This Discussion

Permalink Reply by Dimitar Pouchnikov on October 4, 2013 at 4:13am

this is the result i would like to get

Permalink Reply by Dimitar Pouchnikov on October 4, 2013 at 9:30am

Figirued it out. The loft options node has some extra options beyond the loft node. One of them is adjust seams, which fixed it. Would be great if it were also within the loft node because it took me quite some time to figure out.

Permalink Reply by Dimitar Pouchnikov on October 4, 2013 at 9:34am

Aha, i guess align sections = adjust seams. just a slight inconsistency in names

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service