Curv Rebuild Problem

Hey everybody,

i have a problem with mapped curves. when i ordinary map the curves to a bent surface the result isn´t in the right position. the curvature isn´t similar(left pic). So i

rebuild the curvs and i get a better curvature but then they are these shaky things(right pic).

Can someone tell me why? Please!!

thx for comments.

Replies to This Discussion

Permalink Reply by Caelum Praecelsus Arquitectura on June 19, 2013 at 12:47pm

I have had this problem lately as well when pulling or projecting curves, and have found that even when using the rebuild component the issue you are describing with the shaky lines still exists. My workaround while not the most efficient has been to use the divide curve component and put as many divisions as needed to make an interpolated or basic curve through those points that matches the original - and you will get a smooth curve again.

Permalink Reply by Stephan Schmidt on June 20, 2013 at 3:17am

thx for the idea. i tried it but the result is still the same.

Permalink Reply by Caelum Praecelsus Arquitectura on June 20, 2013 at 2:11pm

Did you rebuild it with the division before projecting/pulling curve or after. If you do it before, then project or pull it should give you the desired result.

Permalink Reply by Stephan Schmidt on June 20, 2013 at 4:07pm

I've tried both

RSS