3d Voronoi cells

Hi guys,

I want to make voronoi cells on a complex geometry,(let's say a torus for example) ,but the 3d voronoi component doesn't recognize the boundaries of the geometry.any help?

thank you!

Replies to This Discussion

Permalink Reply by djordje on May 12, 2013 at 11:47am

Hi Vasilis,

You can intersect the result of your voronoi 3d component with the actual torus:

Attachments:

torus voronoi.gh, 4 KB

Permalink Reply by Vasilis on May 12, 2013 at 3:44pm

thank you djordje!

Permalink Reply by Vasilis on May 13, 2013 at 12:18pm

There is a problem in solid boolean with my geometry.Any Ideas?

Thank you

Attachments:

Untitled.3dm, 381 KB

Permalink Reply by djordje on May 13, 2013 at 12:50pm

You are trying to apply a mesh (created in some other application?) to a definition. Whereas the definition requires Rhino brep, thus an error message appears.
Convert your mesh first (in Rhino use the command: MeshToNURB) then apply the newly created polysurface to the "geometry" parameter from the upper attached "torus voronoi.gh" definition.

Permalink Reply by Vasilis on May 13, 2013 at 1:36pm

thanks a lot!

Permalink Reply by djordje on May 13, 2013 at 2:05pm

I would be very grateful if you could upload Rhino 4 .3dm files, in the future.

RSS