algorithmic modeling for Rhino
Control knob decimals setting busted...
Quick fix bug here I'm sure. Working with a control knob and noticed the following behavior with the "decimals" setting (which should be setting the # of decimals precision to the right of the decimal point correct?):
a) Set value in edit window, effect on range and value settings looks good. But once I press okay, it has no effect on the knob's output or displayed value.
b) When I go back to the knob's edit window the value is always set back to 2.
Cheers-
- B -
Views: 1364
Replies to This Discussion
-
Permalink Reply by David Rutten on
-
Hi Brian,
yup, I'll see about getting it fixed for the next release.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
-
-
-
Finally got around to it, next release will have decimal control for the Dial.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
-
-
Permalink Reply by chombolombo on
-
2 more IDEAS for the rotating knob:
a) Set starting angle of knob (0-360 degrees)
This would be nice for aligning the arrow of the knob at exactly the same angle as the rotating geometry it controls
b) clockwise vs anti-clockwise
Useful for synchronizing rotation with direction of controlled geometry
Cheers!
-
-
Permalink Reply by Martin Siegrist on
-
I have the same issue as Brian...
Happy to see that bug fixed soon! When's the next release coming?
-
-
Permalink Reply by Mitch Heynick on
-
Currently (9.0014) I am still unable to change the number of decimal places... Is that still a known issue?
Thx, --Mitch
-
-
-
Yes, it is, do hope it is fix in the next up-date 0.90050.
Hope you are doing GREAT Mitch, was so nice talking to you!
Andres -
-
-
It has been fixed in 0.9.0050.
(it's also already visible in the Version History, though I don't blame you for not digging through a hundred lines of fine print.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
-
-
-
it still doesn't work for me and I'm running 64 bit rhino 5 and grasshopper 0.9.0014
-
-
-
It has been fixed in 0.9.0050.
Unless you have 0.9.0050, it will not be fixed yet.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
-
-
-
ok so I assume version 0.9.0050 will be available for download soon!!!
-
-
-
Yes, I'm done writing it, there have been 2 testing rounds but we're still trying to find a potential bug with the new installer.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Field Contour
Added by Parametric House 0 Comments 0 Likes
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
