Help creating surface from points not working

Replies to This Discussion

Permalink Reply by David Rutten on May 4, 2013 at 1:40am

Hi Kim,

because your initial surface is trimmed, it does not contain a full grid of division points. Specifically, the points outside the trimmed area are missing. If you want to create a surface from a point-grid, you will need a complete grid.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by David Rutten on May 4, 2013 at 1:48am

See attached. I untrim the base surface, and then retrim it after the deformation.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:

• answer.gh, 14 KB

Permalink Reply by Kim Chan on May 4, 2013 at 1:56am

Thanks a lot David!