loft multiple curves

Replies to This Discussion

Permalink Reply by David Rutten on May 3, 2013 at 6:07am

This would be a lot easier if you scale and move the curves in Grasshopper. It's easy to set up a loft between two sets of curves, but they need to be in the correct order. If you just import both sets from Rhino then there's no guarantee that they will be sorted correctly. However if you only input one set and then create the other set in GH, the sort order is maintained and lofting becomes a breeze (see attached)

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:

• move_scale_loft.gh, 171 KB

Permalink Reply by Neuling on May 9, 2013 at 4:57am

thanks very much!!! both ways worked out perfect!! simple and quick...

Permalink Reply by Danny Boyes on May 3, 2013 at 6:15am

It's simpler to start with just the base curves Move>ScaleNU>Loft. This makes the data matching easier to handle

Attachments:

• scaleandloft.gh, 21 KB

Permalink Reply by Danny Boyes on May 3, 2013 at 6:16am

Of cause its simpler to Scale>Move>Loft :)