Grasshopper

algorithmic modeling for Rhino

Random component turning out not so random results

I am attempting to construct a paneling definition similar to Lunchbox's 'Random Quad Panels' component. I am using a random component to get a random number of curve divisions which I then use to get random t values (0 to 1). Why is it that my t values all seem to match as I have highlighted below? Is there a different method of doing this so I do not get similar t values?

Thanks, Dan

Views: 462

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on April 30, 2013 at 3:55pm

You need to provide a different seed for each branch.

Series with [number of branches] elements -> graft -> S

Permalink Reply by Danila Babko-Malyi on May 1, 2013 at 8:28am

thanks, this works great.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service