Hexagon Grid Deformation

Hi all,

I am new to grasshopper so this is a bit over my head. I am creating a pattern to be cut out on a laser cutter using a hexagon grid. I have attached what I already have but I am looking to begin to deform the grid and pattern to vary in density and size. It makes sense that you might use an attractor to do so but I am not sure how to make it deform the grid and then have the internal shapes follow as well.

This is basically what I am imaging, which is from: http://www.co-de-it.com/wordpress/code/grasshopper-code

However, I can't retreive the file to figure out how apply it to my pattern.

Any help would be greatly appreciated.

Thanks

This is a pic of what I have cut out.

Attachments:

hexagon scale pattern.gh, 52 KB

Replies to This Discussion

Permalink Reply by RWNB on March 6, 2013 at 2:38am

http://www.grasshopper3d.com/forum/topics/how-to-change-a-flat-hexa...

Permalink Reply by Travis Heim on March 6, 2013 at 9:17am

Thank you!!!!!!

Permalink Reply by Paolo on April 19, 2013 at 10:35am

Hi guys,
is possible to add more 2 points attractors to co-de's sistem?

I tried many time to do it, but without success.

Many thanks,

Paolo.

Permalink Reply by Paolo on April 19, 2013 at 1:11pm

Thank you very much for the ghx, now I also Kangaroo!!

I would like to adapt this configuration an irregular surface, but the problem is that I can not trasform the surface in a grid with a exit to "cell as tree", as in the example that you sent me.

I hope find a solution!!

Paolo.

Permalink Reply by Jesus Galvez on April 19, 2013 at 11:07am