Compiling...what am I doing wrong?

Replies to This Discussion

Permalink Reply by to] on March 5, 2013 at 9:17am

Do you compile against the newest release and and which framework are you using?

Permalink Reply by David Stasiuk on March 5, 2013 at 9:23am

I believe I compile against the newest release...I installed the GHA Wizard, selected Rhino 5 64 bit, located the rhinocommon.dll...and from there just built the script, hit compile, and out came the GHA.  Pardon my naivete, where do I find this out the framework and release that I've used?  Can't seem to find it in the project properties...

Permalink Reply by Andrew Heumann on March 5, 2013 at 9:20am

Also make sure "Copy Local" is set to false for all your referenced assemblies

Permalink Reply by David Stasiuk on March 5, 2013 at 9:29am

Thanks, Andrew...they were already set to false (though I don't ever remember doing it :)).  Do I also need to check all imported namespaces beyond the general dll's from which they derive?  For example I use "Imports Grasshopper.Kernel"...do I need to check that below

Permalink Reply by David Rutten on March 5, 2013 at 9:56am

The Wizard should take care of those CopyLocal values.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by to] on March 5, 2013 at 9:26am

check the references

Permalink Reply by David Stasiuk on March 5, 2013 at 9:36am

Thanks...yes, they are all set to False already.  I have in there:

GH_IO

Grasshopper

Rhinocommon

System

System.Core

System.Drawing

System.Windows.Forms

The System.Core says that's it's framework v3.5.  Could this be my issue?

Permalink Reply by to] on March 5, 2013 at 9:38am

are you using 09.0014? and what is your target framework?

if you plan to use only rhino 5 you can go for 3.5 or 4

Permalink Reply by to] on March 5, 2013 at 9:34am

You have to check GH_IO.dll, Grasshopper.dll and Rhinocommon.dll and any dll you will ever use.

best

Permalink Reply by David Stasiuk on March 5, 2013 at 9:40am

cool.  I will do so and try again.  thanks again for your response!

Permalink Reply by David Stasiuk on March 5, 2013 at 9:46am

here's my gha...

Attachments:

• tree_sloth_0.1.gha, 22 KB

Permalink Reply by David Rutten on March 5, 2013 at 9:57am

Yeah, fails to load here as well. Looking into it.

There's a very summary error report in the Rhino command history about the loading failure.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ‹ Previous
• 1
• 2
• Next ›
• Page