Grasshopper

algorithmic modeling for Rhino

offset problem!!!!

i have created a set of curves then lofted them but when i try to offset the surface it does not want to offset. I am new in using Grasshopper so it could be a silly mistake. Thanks in advance.

Views: 381

Attachments:

Replies to This Discussion

Permalink Reply by Jerrimo on July 10, 2010 at 8:07am
Hi Tuqa, you need a target vector for the offset direction. You can use any vector and then amplitute your one distance.
Good luck
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service