Supports trouble on model assembly

Replies to This Discussion

Permalink Reply by Rafael Pastrana on November 18, 2012 at 2:31pm

I plug in one support and it's fine, but when I try to connect another one the first automatically disconnects.

Permalink Reply by Robert Vier on November 18, 2012 at 2:35pm

hold the shift key while connecting. you also might have to 'Flatten' the input (right click on the input character).

holding the ctrl-key while 'connecting' an already connected one removes the wire again.

this is less karamba-related but more general grasshopper interface.

best

Permalink Reply by Rafael Pastrana on November 18, 2012 at 2:41pm

Thanks a lot, Robert. It worked.