vector question

Replies to This Discussion

Permalink Reply by David Wood on June 9, 2010 at 4:28am

Have you tried the flip component?

David.

Permalink Reply by Wieland Schmidt on June 9, 2010 at 4:31am

Yes, but then all vectors flip and I still have some pointing in and some pointing out.

Permalink Reply by Luis Fraguada on June 9, 2010 at 5:41am

Hmm, you could move that center point of each face along the vector and test to see if it is inside your volume, if it is then flip.

Permalink Reply by taz on June 9, 2010 at 10:09am

I agree with Luis, but it also seems that your vectors are generated from surfaces. You could also try to find a way to flip your surfaces based on a guide surface...

I can't remember but perhaps joining the surfaces would force them to be unified.