Offset

Replies to This Discussion

Permalink Reply by kleerkoat on October 9, 2012 at 11:23am

has to do with the curve direction you are offsetting from.

wish i could help more, but i haven't been able to use crvSeam to get consistent curve directions.

Permalink Reply by Raul Matagringo on October 10, 2012 at 1:31am

try this ...

Permalink Reply by Thomas J. Mrokon on October 11, 2012 at 12:14am

you can use flip curve with one guide curve to get consistent directions

Permalink Reply by Mateusz on October 11, 2012 at 7:48am

Join curves (to make closed curves), graft them, offset them by X and -X, check their length, sort by length, choose first item (shorter), flatten. Reverse list if you want only outer offsets. (Sorry for no screen or anything).

Permalink Reply by Dedackelzucht on October 11, 2012 at 9:00am

This is exactly the way it always works. i have used this system quiet a lot. here is the screen.

Best Regards

DeDackel

Permalink Reply by Scuy on October 24, 2012 at 10:41pm

Thanks ,ryles ,Raul Matagringo ,teejot , Mateusz ,Dedackelzucht !

I tried offset both sides,and sort.It succeeded!