Constraining a Voronoi skeleton inside a Brep

Replies to This Discussion

Permalink Reply by David Rutten on September 27, 2012 at 11:54am

Very chewing gum on the pavement...

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Tyler Zalmanzig on September 27, 2012 at 2:35pm

haha. Very true. Not the look i'm trying to achieve unfortunately... Any ideas on a solution?

Permalink Reply by Michael Pryor on September 27, 2012 at 12:09pm

do you mean to contain like so? http://www.grasshopper3d.com/photo/voronoi-klein?xg_source=activity

Permalink Reply by Tyler Zalmanzig on September 27, 2012 at 2:25pm

yeah, That is what i'm looking to do. But as you can see the current definition I have breaks the boundaries of my geometry. 

Permalink Reply by Michael Pryor on September 30, 2012 at 1:38pm

Here is how.

Attachments:

• voronoi3d in brep.3dm, 119 KB
• voronoi3d in brep.gh, 4 KB

Permalink Reply by Tyler Zalmanzig on October 1, 2012 at 6:53pm

Thanks for the reply. That is the look i'm going for but I was trying to get it to work with my original definition. I have worked that one to where I like the look of it but I just can't seem to keep it in the BRep. I tried solid intersection and mesh intersection on the definition I was using but both fail to work. I assume because its trying to intersection a mesh and a BRep together?  

Any thoughts on what to do from here?

Permalink Reply by Michael Pryor on October 1, 2012 at 10:09pm

Well you said brep. Brep is not a mesh.

Permalink Reply by Pablo J on February 20, 2015 at 9:34am

Hi guys. I am new on grasshopper and it is driving me crazy. I need some help. I downloaded what you did and I apllied on one of my models and worked fine. Now I am trying to get a tridimensional body like the picture attached but I cannot figure this put. I am clueless. . I cannot use a standar surface, I must use a fixed STEP model of one of my client. Could you give me some advice?

Many thanks.

Attachments:

• example.jpg, 48 KB