Lofts with points

Replies to This Discussion

Permalink Reply by Danny Boyes on June 20, 2012 at 4:25am

You could make a very small curve at the location of the Point

Permalink Reply by Diego on June 20, 2012 at 7:15am

The good things about using point in a loft is the possibility to make "closed lofts" they end in no-hole. This usually is solved with a revolution curve or similar, but those are more complex situations which i'd prefer to avoid in grasshopper.

Permalink Reply by Yoann Mescam (Systemiq) on June 20, 2012 at 10:57am

If the curve is really small, rhino will see no hole.

Try attachment.

Attachments:

• LoftToPoint-Systemiq.gh, 9 KB

Permalink Reply by phillip on June 20, 2012 at 4:41am

Extrude Point

Permalink Reply by Michael Pryor on June 20, 2012 at 7:56am

Permalink Reply by Diego on June 20, 2012 at 8:21am

Well, yes. But if you want a doblecurved surface with defined sections by curves in-between.... 

Permalink Reply by Michael Pryor on June 20, 2012 at 8:40am

attach a rhino file. Being vague will not get results :)

Permalink Reply by Diego on June 20, 2012 at 9:36am

Here you have a simple example of what I am looking for...

Attachments:

• loft to point.3dm, 103 KB

Permalink Reply by Michael Pryor on June 20, 2012 at 10:18am

You can always just add the tip into the lists.

Attachments:

• ADD TIP.gh, 3 KB

Permalink Reply by Diego on June 21, 2012 at 4:01am

Got it. It's a good way. I'll post something when finished.

Thanks  a lot Michael. 

Permalink Reply by NaamaGal on May 11, 2017 at 8:59am

Doesn't work in my case..

Permalink Reply by Chapulin Colorado on May 11, 2017 at 12:23pm

whats your input curve?

like Michael Pryor said:attach a rhino file. Being vague will not get results :)

• ‹ Previous
• 1
• 2
• Next ›
• Page