Quick question on how these forms are generated through Grasshopper (Images below)

Replies to This Discussion

Permalink Reply by Ángel Linares on April 27, 2010 at 3:39am

I think that when you want to modify some geometry, you must begins one step lower: if you want to modify surfaces is good to think about modify curves that generates that surfaces; if you think about curves, try to modify points that generates it, and so on.

First trnasformations are only rotations and a closed loft (i think).

Hope this helps you.

Best Regards.

Permalink Reply by wannes lernout on April 27, 2010 at 4:25am

The top image are moebius strips and 'solids'.
I've attached the defenition.

Greetz

Attachments:

• moebius2.ghx, 335 KB

Permalink Reply by Jeremy Crocker on April 28, 2010 at 1:38am

Thanks for the help, guys.

Quick question about the second image. Are those isocurves extracted from a sphere?

Cheers.