Change in Divide Surface component?

I've noticed that the updated Divide Surface button appears to behave differently from the previous one in older versions of GH.

When trying to create sets of 4 point grids on surfaces, using the often demoed workflow of Surf Param > Divide > SubSrf > Surface Divide to get the 4 points of each sub surface. The current Divide Surface button only reads out the 0 and 1 points. Whereas the old component on the exact same definition will read out 0, 1, 2, 3 as hoped!

Is there a simple reason for this that's passed me bye? - i've been head scratching all afternoon...

Thanks,

David.

Replies to This Discussion

Permalink Reply by David Wood on April 8, 2010 at 10:40am

Images attached... just to check i'm not going crazy...

Attachments:

OLD Surface Divide.jpg, 502 KB
NEW Surface Divide.jpg, 487 KB

Permalink Reply by G on October 21, 2010 at 6:51am

Hi David

I have am having the same problem as you. I have followed the advice from Mario and installed the link he posted, but it did not solve my problem. It still shows the same sequence of points. Was your problem solved after installing the fix?

Gordon

Permalink Reply by Danny Boyes on October 21, 2010 at 6:59am

not sure what fix you can install the new component handles the data different, that's all there is to it. If you want to manipulate the data to look like the old component then have a look here: http://www.grasshopper3d.com/forum/topics/grasshopper-060059-availa...

Permalink Reply by G on October 21, 2010 at 7:11am

Danny

Thanks a mill, I used the pathmapper and it worked brilliantly.

Cheers!

Permalink Reply by MARIO VERGARA on April 8, 2010 at 10:54am