load a grasshopper in rhino?

Replies to This Discussion

Permalink Reply by Mauricio Rodriguez on March 30, 2010 at 2:57pm

type "grasshopper" in the command line ...

Permalink Reply by Sameer Kumar on March 30, 2010 at 4:31pm

Does your GH definition use any rhino objects as references? If those objects do not exist in your current Rhino file, there would be nothing visible and those components would be colored orange in GH.

Permalink Reply by idtasos on March 31, 2010 at 1:04am

That's the point! It starts by creating an elipse with 2 sliders and even if i manually set the plane, nothing is created. So the rest of the definition can not work.

Permalink Reply by wannes lernout on March 31, 2010 at 1:41am

Check out preview mode state for the grasshopper file aswell as your individual components inside the file!