Grasshopper

algorithmic modeling for Rhino

custom paneling from mesh (scanned object) and unique numbering of panels

Hi,

Total newbie with GH, I'm having a bit of trouble trying to get panelingtools to work with my input surface since it is a mesh. I've been trawling the discussions here for similar problems but to no avail. Is there a an easy way of accomplishing a custom paneling of a mesh surface in GH? and yes I'd like to do a unique numbering of the panels afterwards as well. It's for a project with 3d printing of ceramics at the dkds.dk Danish Design School.

Any input appreciated ;)

Cheers

Lauge

Views: 955

Attachments:

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on March 21, 2012 at 8:46am

Here is a single surface from your mesh (which actually was a polysurface looking like a mesh).

There is a big hole in it because I crunched it.

Attachments:
Permalink Reply by Lauge Brimgiest on March 23, 2012 at 4:06am

Hey thanks a bunch but how did you make a polysurface in to a single surface? crunched? 
 

Permalink Reply by taz on March 23, 2012 at 11:03am
Permalink Reply by Johan Rooijackers on March 22, 2012 at 6:03am

It looks like it needs to be rebuilt first. Then panelingtools should work fine. 

Permalink Reply by Lauge Brimgiest on March 23, 2012 at 10:19am

How do you guys make such an assesment? when I check the object Rhino says its valid.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service