Problems with evaluated points on Kangaroo

Replies to This Discussion

Permalink Reply by Juan_P on February 29, 2012 at 1:24pm

Megan,

 

I think it would be helpful if you post definition and 3dm file so the question can be better understood.

Permalink Reply by Hannes Löschke on February 29, 2012 at 3:20pm

Normally this is due to the anchor points not being coincident with the mesh vertices. Anchors need to be not only intersecting the mesh but also exactly on the loaction of mesh vertices.

There is a way to make sure that anchor points are valid. If is doesn't matter that ancors are exactly where you place them, use the ClosestPoint with all the mesh vertices and the original anchors. This selects the nearest mesh vertices to your original anchor points.

You can also move the nearest mesh vertex towards the the orignal anchor location, reinsert the moved point and rebuild the mesh.

Permalink Reply by Mateusz Zwierzycki on February 29, 2012 at 7:24pm

Just use kangaroo settings -> tolerance :) (not sure if anchor points will move)