Kangaroo Mesh Inflation

Replies to This Discussion

Permalink Reply by Shannon on July 26, 2011 at 5:35pm

Figured it out. if anyone is interested here is a quick test I did this morning possibly inefficient but works for what I need it for

Attachments:

• inflation with repel.ghx, 349 KB

Permalink Reply by Agnieszka on February 14, 2012 at 9:02am

hi 

just found this post as I was searching for a definition that models kind of ETFE bubbles. 

But It seems like I can not open full definition as I am missing some komponents

Which version of Grasshopper and Kangaroo are you using? 

Permalink Reply by Hooman Homayooni on February 5, 2015 at 8:33am

First of all thank you very much for your post 

it seems that my grasshopper lacking the component MESH INFLATE

what add on should I install to add this component to my grasshopper engine and make your algorithm run?

looking forward to your answer.

my best regards in advance:)