surface from points

Hi, I would like to make a surface from some points I've created. The points are all in the same xy plane and the surface I would like to create is a polygon. I've tried this using the surface from points component, but I get not the result I want. After seeing this post (http://www.grasshopper3d.com/forum/topics/logic-for-surface-from-po...), I thought the U-input should be set at 6 for my surface, but then it says "The u-count value is not valid for this amount of points". When I set the value at 2 or 4 , it does create a surface, but not the one I'm looking for. Here is a screenshot of my points with the surface created for U=2.

Replies to This Discussion

Permalink Reply by Michael Pryor on December 16, 2011 at 2:34pm

Please always post your definition, its easier that way.

Permalink Reply by Goossens Niels on December 16, 2011 at 2:38pm

Hi Michael, what do you mean with my definition? I don't understand.

Permalink Reply by Michael Pryor on December 16, 2011 at 2:51pm

upload your grasshopper and rhino files.

Permalink Reply by Goossens Niels on December 16, 2011 at 2:56pm

These are my files

Attachments:

surfacefrompoints.3dm, 22 KB
surfacefrompoints.gh, 20 KB

Permalink Reply by Michael Pryor on December 16, 2011 at 3:11pm

Im sorry I still dont understand what you want the result to be. can u model what it should be in rhino and show a screenshot?

Permalink Reply by Goossens Niels on December 16, 2011 at 3:31pm

I've never used rhino outside of grasshopper, but I've drawn the surface in photoshop so you can see what it looks like. Hope you understand my intentions now?