Point Grid in GH 0.8.0062

Hi,

I am not able to create a point grid in GH 0.8.0062 as I did in previous versions (see attached screen capture): now that the Point (XYZ) is updated, and the previous component is 'OLD' I am unable to setup a point grid in the same manner. The panels show that the data output are very different. I was wondering if anyone had any tips or ideas of what I could try. I have been trying several things, including playing about with Path Mapper, but no success - my brain is a mush. Any tips would be appreciated (unless I am missing the obvious). Thanks

Attachments:

pointgrid.jpg, 467 KB

Replies to This Discussion

Permalink Reply by Michael Pryor on December 15, 2011 at 8:39pm

You have the second series plugged into both y and z of the new one. That's why.

Permalink Reply by Astro/Naught on December 15, 2011 at 8:43pm

Hi Michael,

Thanks for the heads up - amateur mistake there. I fixed it and I still get the same result.

Permalink Reply by Michael Pryor on December 15, 2011 at 8:49pm

Well actually you only need one series to plug into all x y and z for a square 3d grid. Make sure p input is set to plane xy. Then I believe set the component to cross reference. Sorry I'm computer less at the moment.

Permalink Reply by Astro/Naught on December 15, 2011 at 8:51pm

You may be computer less but I am was brainless for a few moments there. I got there a wee bit before you but thank you anyhow for taking the time to help. Much appreciated Michael.

Permalink Reply by Astro/Naught on December 15, 2011 at 8:48pm

Boom! I knew the answer was obvious. It is fixed! (Sometimes it's just good to get the problem out there).

RSS