voronoi cut

Replies to This Discussion

Permalink Reply by fernando molas garcia on December 10, 2011 at 10:20am

Hello jon

replied your mail. thanks for extending the license.
I can not use plugins to achieve something similar to the image.

regards

Attachments:

• vor_f.3dm, 81 KB
• voronoicurva_4.gh, 10 KB

Permalink Reply by fernando molas garcia on December 10, 2011 at 5:32pm

Sorry jon your solution works great! does just what I need

Permalink Reply by fernando molas garcia on December 9, 2011 at 5:20pm

another attempt, but there ...

Attachments:

• vor_f.3dm, 90 KB
• voronoicurva_4.gh, 10 KB

Permalink Reply by fernando molas garcia on December 9, 2011 at 5:49pm

if the contour is not very "distorted" works ... but there must be another way to make a better filter.

Trim function that marks the error?

Permalink Reply by MARIO VERGARA on December 9, 2011 at 6:40pm

you can offset your curves in both directions , positive and negative

then test witch one is smaller than your original area, with dispatch you can select the ones you need

i added a fillet just for fun

in some cases some kinks are produced due to the point positions on the voronoi diagram

in those cases just move the points a little bit, so the diagram is recomputed

best

Attachments:

• voronoicurva5.gh, 10 KB

Permalink Reply by MARIO VERGARA on December 9, 2011 at 6:44pm

by the way...the offset in the border is half the distance compared to the offset in the center cells

that is because the center cells have two offsets, and the border just one

is that making any sense???

Permalink Reply by fernando molas garcia on December 9, 2011 at 8:30pm

I like your solution ... I will look better!

Permalink Reply by fernando molas garcia on December 9, 2011 at 9:28pm

what is the benefit of choosing the cell area offset less than the original cells?

Permalink Reply by MARIO VERGARA on December 10, 2011 at 7:50am

because when you offset the curves sometimes they have inner and outer directions, that is why i had to offset then again with a negative value.

Permalink Reply by fernando molas garcia on December 10, 2011 at 9:57am

I understand

Permalink Reply by lucas cañada on December 10, 2011 at 3:31pm

Hi Fernando, one more approach.

Attachments:

• voronoicurva_4.gh, 8 KB

Permalink Reply by fernando molas garcia on December 10, 2011 at 5:48pm

I do not get the same result!

wrong?

Attachments:

• voronoicurva_6.gh, 8 KB
• vor_f.3dm, 81 KB

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page