Inflated Mesh offset

I've been working with an inflated mesh definition where a voronoi definition determines the size and shape of the hanging mesh. I've offset and fillet the voronoi grid, but can't figure out how to make a surface between the offset lines of the voronoi. Pretty much to make a path between these half bubbles.

(I plan on animating the grid moving voronoi that's the reason for the curves and animation def. in grasshopper)

Attachments:

inflated mesh offset.3dm, 161 KB
Voronoi_grouping_mesh.gh, 35 KB

Replies to This Discussion

Permalink Reply by taz on December 2, 2011 at 11:35am

It's not the most straightforward way but you can create BReps from your voronoi openings and use them as punch outs for a surface with [Trim Solid].

Permalink Reply by m.english on December 2, 2011 at 12:31pm

Thanks for the help. I found it easier just to make a boundary surface and flatten both curve sets. If anyone is trying to use this definition, its important to realize that the offset is a negative number.

Attachments: