installation problem with grasshopper 0.8.0051

Replies to This Discussion

Permalink Reply by Chris Walsh on November 16, 2011 at 12:02pm

Did you just install a new copy of the component set? If so when you load a solution that used the previous set, you should delete the integrator component and recreate it. The integrator went through some changes and Grasshopper is warning you about the conflicts.

Specifically the error you're seeing is from when we changed the Start Points input to take a list, and not a single point at a time. This was a change for the better but causes an error the first time you load a previously saved solution.

 

Permalink Reply by Massimiliano Trave on November 17, 2011 at 4:59am

Thanks for the  reply.

is there the possibility to get the spm previous version within which the sample files work?

My example files are these:

Attachments:

• SPM Vector Components Examples.zip, 563 KB

Permalink Reply by Chris Walsh on November 17, 2011 at 8:18am

The examples have not been updated yet sorry! They will still work if you recreate the integrator and settings components appropriately, but we haven't had the time to yet do so.

I don't currently have access to a version of the toolkit that works with the examples. Things have changed a lot since May! 

Permalink Reply by Massimiliano Trave on November 17, 2011 at 9:14am

ok thanks, i understand,means that I will wait the update the examples becuase i don't know spm component and  so i have problem to recreate the integrator and settings component.

thank you anyway

Permalink Reply by Massimiliano Trave on November 19, 2011 at 7:45am

in addition to the example file is there a primer about spm ?