Improved List SME

Due to some good feedback that the List SME item and value functions should separate I have updated the clusters if anyone is interested. List SME index {List SME(i)} outputs the start, middle, and end index of a list and List SME value {List SME(v)} outputs the item values at the start, middle, and end of a list. Download the .ghuser files and drop them onto the GH canvas, they install in the lists tab.

Thanks to Danny Boyes

Attachments:

List SME (i).ghuser, 7 KB
List SME (v).ghuser, 9 KB

Replies to This Discussion

Permalink Reply by Rémy Maurcot on September 14, 2011 at 10:16am

Hi Michael,

I want to use your components. *. guser how to use this kind of components?

Permalink Reply by Michael Pryor on September 17, 2011 at 5:26pm

just download them and then drag them onto your grasshopper canvas, they will install in the sets>list tab.

Permalink Reply by gotjosh on October 6, 2011 at 5:41am

great minds think alike man...

http://www.grasshopper3d.com/forum/topics/if-i-have-to-type-i-1-int...

but i like your approach, i'll prolly find use for both over time, thanks :)

Permalink Reply by Michael Pryor on October 6, 2011 at 7:40am

Thanks, I made it while I was making a definition that required a lot of splitting in the center of lists and had min and max extremes I wanted to call out, I'll check yours out as well.

Permalink Reply by gotjosh on October 6, 2011 at 11:39am

i like this SME concept... working on one for curves:

Attachments:

Curve SME.ghuser, 6 KB

Permalink Reply by Michael Pryor on October 6, 2011 at 11:57am

nice

Permalink Reply by Michael Pryor on October 6, 2011 at 12:06pm

heresi also a cluster I made cull boarder or cullb, made it for screens so my geometries could not fall off the edge of my divided surface. This was also the reason I was asking you about adding {0} to lists, in this case I did not. http://www.grasshopper3d.com/forum/topics/cull-border-cluster

RSS