one surface from 8 curves?

I have 8 curves that I want to create a single surface from. Is there anyway I can do this?

Replies to This Discussion

Permalink Reply by Peter Kluck on September 29, 2011 at 12:07pm

This works fine:

http://www.grasshopper3d.com/profiles/blogs/patched-interwoven-surface

it´s done by Lars Renklint

Best regards, Peter

Permalink Reply by Michael Pryor on September 29, 2011 at 12:20pm

or if they are "sectional" curves representing an untrimmed surface you can just loft them.

Permalink Reply by Lauren Campbell on September 29, 2011 at 1:43pm

Thanks Peter that worked out great.

Permalink Reply by Lauren Campbell on September 29, 2011 at 2:45pm

I need to offset the resulting surfaces but it seems like this patch creates a surface in rhino but not in GH. Any ideas for the offset? I can use offset surface in GH but I still need the surface.

Permalink Reply by Peter Kluck on September 29, 2011 at 11:55pm

Permalink Reply by Lauren Campbell on September 30, 2011 at 12:42am

I have that but now I have intersecting offsets and need to get the excess surface trimmed off.

Permalink Reply by Peter Kluck on September 30, 2011 at 4:11am

Just send your .gh file it's easier to find a solution.
Best, Peter

Permalink Reply by Lauren Campbell on October 12, 2011 at 9:27pm

I also need to create a surface in the space between the offset and the original planes. I don't know if there would be an easier way to go about this or not. I'll basically have the shape made into a hollow solid. If you understand that. My file is too large. I will make a simpler version of what I'm trying to achieve and send it to you.

RSS