Missing line in the grasshopper definition

Replies to This Discussion

Permalink Reply by Danny Boyes on September 26, 2011 at 4:25am

Why is there no line?

The lines are created from the four corner points of a subsurface. The U Lines are created by using the "bottom" two points and the V are created by using the "Left hand" points. Therefore there are no upper edge or right hand lines for each surface. If you were to introduce two more Line components to created the upper (2,3) and right hand lines (1,2) then you would be generating duplicates everywhere except the outer edges of the original surface.

And how can it be drew through grasshopper without manually drawing it in Rhino.

Draw all the lines the make up the borders of each SubSurface and then select the correct lines from the "extras" see attached

 

Attachments:

• missingLineSolution.gh, 7 KB

Permalink Reply by djordje on October 4, 2011 at 4:15pm

Thank you Danny !!!