Grasshopper

algorithmic modeling for Rhino

division of trimmed surface

Hi,

 

This might be very easy but I cannot achieve it so any help would be very greatfull

I have a trimmed surface which i want to divide as shown on the attached image.

Basically I have a trimmed surface where i would need the division points to travel from edge 1 to edge 2 while edge 3 & 4 would need to act as attractor curves. So I would also need points on edges 3 & 4.

Any ideas?

 

ps. I have also attached the rhino file

Thanks in advance

L

 

Views: 1566

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on September 17, 2011 at 5:48pm
Using your edge naming.

Chris
Attachments:
Permalink Reply by Lukas Bobotis on September 18, 2011 at 2:56am

Great Chris!

I'll study your solution right away!

Really appreciated..!

Permalink Reply by Lukas Bobotis on September 19, 2011 at 1:33am

Is there a reason why the points on the two shorter edges are not equally distanced?


Permalink Reply by Lukas Bobotis on September 19, 2011 at 1:44am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service