physic catenary simulation

Replies to This Discussion

Permalink Reply by Daniel Piker on July 17, 2011 at 8:40am

Sure - just input the control points to Geometry and build the surface from the outputs as shown in this definition.

Attachments:

• NurbsCatenary.ghx, 140 KB

Permalink Reply by Maurizio Barberio on July 17, 2011 at 9:02am

Thank you! i'll try it later ;)

Permalink Reply by Maurizio Barberio on July 19, 2011 at 10:22am

Daniel why the anchor points of the nurb are not precise when i'll move them with pointOnCurve slider? This is the screen shot. thank you!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

I try to densify the lines of PointOnCurve but the nurbs not responds well

Permalink Reply by Maurizio Barberio on July 19, 2011 at 3:06pm

i've done Daniel ;)