Close Curve

Replies to This Discussion

Permalink Reply by David Rutten on April 8, 2010 at 10:44am

How do you want to close it? Move the endpoints together? Create a linear closing segment? Create a smooth closing segment?

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by kermin chok on April 8, 2010 at 10:54am

Hi David,

The most likely case is "create a smooth closing segment" but having the 3 options available that can be specified would be useful.

I'm doing this to clean up reference curves from Rhino without messing with the original Rhino geometry because this geometry is being provided by another party.

I'm looking for equivalent function when we use the "CloseCrv" command in Rhino.

Thanks.

Permalink Reply by David Rutten on April 8, 2010 at 11:11am

Ok, I can easily code up #1 and #2, smooth curve blending will require some Rhino SDK support.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Garcia del Castillo on May 4, 2011 at 5:17am

Hi! Did that code get somewhere...?

Permalink Reply by Danny Boyes on May 4, 2011 at 9:01am

If you cannot wait for a component you could try one of these grasshopper methods.

 

UPDATE

Attachments:

• CloseCurve.ghx, 790 KB

Permalink Reply by Anna Waldon on May 19, 2011 at 3:10am

This works great for one curve. But what if I have many curves, some closed and some not? I am struggling to prepare the data in the right way for these snippets to work.

Permalink Reply by Danny Boyes on May 19, 2011 at 3:36am

At lunch I'll have a look at sorting the path structures out for multiple curves.

Permalink Reply by Anna Waldon on May 19, 2011 at 5:39am

Thank you, Danny. I managed to do it using your contribution here but would be keen to understand how to manage the paths in this example for the future. So, if you could add a comment or two it'd be most appreciated.

 

I also noticed that the joint curves are often not planar even if the inputs are planar (and even if the results look fairly planar). Which is surprising. Is there a way to keep them all in one plane?

 

Thanks again.

Permalink Reply by Danny Boyes on May 19, 2011 at 12:31pm

The only two thigs that needed changing were to graft the input curves and swap the Filters for the Pick N Choose component.

Attachments:

• CloseCurve_PickNChoose.ghx, 791 KB

Permalink Reply by Anna Waldon on May 23, 2011 at 9:13am

Thanks, Danny. This works.