Circle extrusion ?

Replies to This Discussion

Permalink Reply by mohammad shaiqueuddin on May 13, 2011 at 8:38am

Hi Javier,

I guess you need to use the sweep2 rail command.

It will be even easier for me to tell you the exact thing only if you can post some images of what you want.

But first try the above one.

Permalink Reply by javier duran on May 13, 2011 at 2:33pm

Thank you, It was really the command i was looking for. Is there a way i can divide this rail every certain distance ? The red lines drawn below might give you an idea of what i want. Thanks again.

Attachments:

• Untitled.png, 174 KB

Permalink Reply by mohammad shaiqueuddin on May 15, 2011 at 4:02pm

Hi Javier,

Do you want to divide the whole rail or a specific part of it?

And, Do you want to divide in equal length?

 

Shaique

Permalink Reply by Vishal Sawlani on May 13, 2011 at 9:55am

hey javier....u can use the  PIPE command....if its a polyline....it will turn it into a pipe.....its normally used for making railings/poles etc

 

Permalink Reply by javier duran on May 13, 2011 at 2:34pm

Thank you, Sweep2 worked great for me.