surface through curve networks...

Hi Guys , could some one plz tell me how to create a surface between a set of curves ........i need the surface exactly the way it looks in the file i provided below...i used the curve network option to create that surface in rhino , i need to do the same with grashopper.....i m relatively new to grasshopper...

Attachments:

howto.3dm, 93 KB

Replies to This Discussion

Permalink Reply by Luis Fraguada on September 30, 2009 at 3:24am

It can just be a loft no? I extracted the curves in one direction and lofted, the surface looks the same though the domains are different. So you would need to figure out how you would form curves that way...

Permalink Reply by Muzammil Contractor on September 30, 2009 at 3:37am

hmm thanks for ur reply luis ..but i didnt really get wht u said ...could you explain through the file i attached , if possible...i have a project that m doing at the moment n its really ugent..i have tried some ways but didnt really get the desired result...i know it might be simple ..but since i m new to working with grasshopper i m finding it a little hard to figure out ways quickly...

Permalink Reply by Luis Fraguada on September 30, 2009 at 4:36am

The surface does not really require a network of curves, just the curves in one direction (though I am assuming a lot about the parameteriztion of the surface). I extracted those curves and fed them into a Params.Curves...and those to a Surface.Freeform.loft in GH. Keep in mind the order which you use to select the curves s they will affect the loft. Without knowing how you generated the surface curves I cannot help you too much in explaining how you would control those curves.

Permalink Reply by Muzammil Contractor on October 5, 2009 at 3:26am

hi luis , thanks for the explaination ..sorry my computer stopped working hence couldnt reply....i followed your explaination and got very close to what i wanted ...thanks again...

RSS