Octopus window issue!

Hey all,

I've been trying for hours to open the octopus window by clicking on it!(screenshot attached), the window isnt even minimized somewhere on the screen, i searched a lot.

I removed it and copied it again to the component folders and reopened rhino and gh, yet nothing have changed!

Any help?

Fares

Attachments:

2019-11-27 17_03_24-Grasshopper - B_EMO_WindMill_Village_init_.png, 453 KB

Replies to This Discussion

Permalink Reply by Christos Kollias on September 21, 2021 at 5:12

Hello,

I am getting exactly the same problem and i havent found a solution yet. Did you find the aswer to the problem?

Permalink Reply by Kleber Oliveira on October 22, 2021 at 2:21

Hi all,

I'm having this issue as well. I've tried everything, remove and copy, uninstall and installation of Rhino+Grasshopper.

I'm using Rhino 7 and Grasshopper 1.0.0007.

Thanks in advance

Permalink Reply by Bill Halversen on November 15, 2021 at 13:11

I think

"Object reference not set to an instance of an object."

means that your connecting Octopus (Loop) to a grasshopper component

that does not have data in it yet .

Permalink Reply by Kleber Oliveira on November 16, 2021 at 7:56

Hi All,

The problem I'm having now is when I try to run the Octopus component it suddenly crashes and closes the Rhino + GH application.

Permalink Reply by BerniceKDaniels on March 20, 2024 at 0:57

I am new here and want to ask a question. Can I ask it? Dear friend, The submission of the essay is near, and the essay is not fully ready. I need some inspiration. Then I have a solution for you: Domypaper https://domypaper.com/ is a website where you can get your work done. I have ordered a few from them, and I am amazed by their work. You can try them out.

RSS