Weaving diagrid

Hey guys, I have a definition of a weaving diagrid which I want to put as a skin facade to the elements in my project, my problem is that when I try to put it in one Pipe it takes too long or the program crashes, I was wondering if someone could take a look at my definition and tell me what I´m doing wrong and a solution for it. I would really appreciate an answer! Thanks!

-Jorge

Attachments:

facade logic weave diagrid.ghx, 610 KB
Diagrid pattern.png, 216 KB

Replies to This Discussion

Permalink Reply by JORGE LUIS TREVIÑO GARZA on April 13, 2011 at 7:23pm

Im using a definition which allows to take a pattern into a bounding box and then repeat it along a surface, but Im using pipes and my gh crashes... any ideas would be appreciated, thanks!!

Permalink Reply by Dedackelzucht on April 14, 2011 at 1:08am

Can it be that you are using to many curves for the pipe?

Attachments:

facadelogicweavediagrid_DeDackel.ghx, 514 KB

Permalink Reply by Pieter Segeren on April 14, 2011 at 4:49am

Hi Jorge, couldn't you construct your diagrid/weave directly on the big surface? I also think you could use the Pipe instead of Loft. Maybe you can get some ideas from this discussion: http://www.grasshopper3d.com/forum/topics/translate-lines-to-curves...
Hope this helps.

RSS