Remesh with Weaverbird?

Hello everybody,

I've made a script in Grasshopper, at the end of my script I've got some terrible breps. When I'm making a mesh from this terrible brep I'm getting also a terrible mesh.
Is it possible to build up a totally new well organised mesh of this with weaverbird?
Other suggestions are also welcome.

Thanks in advance,

Wess

Replies to This Discussion

Permalink Reply by Giulio Piacentino on April 4, 2011 at 5:15am

Hi Wess,

this is an interesting topic. The Rhino mesher normally should do this task (if the mesh is not "too terrible" :) . Could you post a picture of the Brep?

Thanks,

- Giulio

Permalink Reply by Wess on April 4, 2011 at 6:03am

Hi Giulio,

My intension is to give the mesh some body, afterwards I want to smooth it down.

I think that I need a clean mesh to reach this.

Wess

Permalink Reply by RWNB on April 4, 2011 at 6:49am

i see the problem more in the preparation of the surfaces.
your method is a bit unsuccessful. i try to do something similar.
maybe i can help you with it.
good luck

Permalink Reply by Wess on April 4, 2011 at 7:42am

Thanks RWNB, yes that could be. I did it al with a bezier curve(maybe not that efficient, I agree). I will look to that.

But could you upload your script, so that I can learn something of it?

And can you give your breps rather body?

Permalink Reply by RWNB on April 4, 2011 at 7:54am

i have recently started to work with this.
currently it is the representation of a local component.
it has potential. (:

Attachments:

Test.3dm, 49 KB
Test.ghx, 461 KB

Permalink Reply by Wess on April 4, 2011 at 8:03am

Thanks, very useful. But what version of grasshopper do you have?

Not al the components are linked together.

Permalink Reply by RWNB on April 4, 2011 at 8:09am

grasshopper 08.0007.

because of the clarity i turned off the wire visibility.

Permalink Reply by Wess on April 4, 2011 at 8:20am

Yes, I know but I've an earlier version. 08.006 or something like that.

But thanks, I wil try it in a different way. I will let you know if there is some progress.

Permalink Reply by RWNB on April 4, 2011 at 8:29am

then lots of success. i am curious what you do.
when i have the time, i will also try to bind
the principle of this component in a hexagonal grid.
we can further contuinue to exchange.

incidentally, it makes no sense to work with the old grasshopper version.