help a noob?

my first attempt at this.

i have a solid form in rhino with two other solids spaces boolean-ed out of it. the remainder solid form is cut into fins arrayed throughout it. my tutor helped me write the grasshopper formula and it generates the desired result. but i can't select that result to use in any way...?

i have selected the rhino forms and baked them. but nothing happens.

Replies to This Discussion

Permalink Reply by Luis Fraguada on September 12, 2009 at 11:22am

Hana,
So you have already tried to select and bake the last (right-most) component and nothing bakes? From time to time this happens to me too...sometimes I have to close GH n Rhino and open everything up again...
Luis

Permalink Reply by David Rutten on September 12, 2009 at 4:54pm

Try plugging the BRep data into a free floating BRep parameter and bake that. Does it work then?

Permalink Reply by Luis Fraguada on September 12, 2009 at 5:09pm

Yes, this also does it from time to time...but not always...

Permalink Reply by David Rutten on September 12, 2009 at 6:19pm

There is a bug in Grasshopper which prevents Generic parameters from baking their contents. I've already fixed this and it will be available soon.

If a BRep component fails to bake, then it's a separate bug. We'll see what happens when the new code goes online. The entire Baking system has been rewritten.

Permalink Reply by Hana Kobe on September 14, 2009 at 12:16am

thx for the comments gentlemen, turns out this supernoob tried to bake the wrong component! *blush*

but am facing a new challenge of adding struts (running parallel above the tangential curve which the fins are arrayed on) as bracing for the fins.... how?

see attached birds eye view.jpg and the full gh script on shelter.jpg (attached with first post)

RSS