Grasshopper

algorithmic modeling for Rhino

How to make joints fixed or as a hinged connection?

hi,

I was trying to use the beam-joints component, but i do not really understand how it should suppose to work, I tried to use it on only the beams so the end joints would be fixed if i toggled the Tx, Ty and Tz, but that didnt work as i would thought. Does someone know how to change connections/joints to the preferd connection type?

Regards,

Giorgio

Views: 596

Replies to This Discussion

Permalink Reply by Karamba3D on January 15, 2019 at 1:10pm

Hi Giorgio,

did you have a look at the examples which come with Karamba3D? You can find examples with hinges under e.g. '...\Rhinoceros 5.0 (64-bit)\Plug-ins\Karamba\Examples\TestExamples\Beam_Joint'. One gets to the Karamba-folder by double-clicking on the Karamba3D desktop icon.

There is also a section on hinges in the Karamba3D manual.

Best,

Clemens

Permalink Reply by Giorgio on January 16, 2019 at 12:30am

Hi Clements, thanks for the reply. Going to read in the manual and the examples. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service