COM class factory issue

Hi to all

I want to try this plug-in. I have installed all requirements (Rhino 5, Grasshopper, Ghpython, MapWinGIS).

I have defined the MapWinGis folder because at the first attempt the installation folder was not recognized:

But now the panel displays this COM class factory error

I have followed all the instructions at point 1 without results.
Someone else has had the same problem? How can I solve?

Regards,

Replies to This Discussion

Permalink Reply by djordje on May 7, 2018 at 10:20am

Hi Francesco,

Thank you for reporting this issue again!

Did the same previous solution worked on your new PC or not?

Permalink Reply by Francesco on May 8, 2018 at 6:54am

Hi Djordje,

no, it didn't work.

Permalink Reply by djordje on May 8, 2018 at 11:51am

Hi Francesco,
I do not have a laptop at the moment, in order to offer some other solution.
But once I buy it in the next few weeks, we will try something.

In general the message that you got is raised because MapWinGIS libraries where not registered to Window's registry. At least that is the initial assumption. Can you use Gismo on your other PC until we try to solve the issue on your new PC?

Permalink Reply by Francesco on May 9, 2018 at 5:30am

Yes, I can.
Thanks,
F.

Permalink Reply by Francesco on October 15, 2018 at 12:39am

Dear Djordje,

are there some solutions about this issue on my laptop?

Permalink Reply by djordje on October 15, 2018 at 9:34am

Hi Francesco,

Sorry for not getting back to you. I forgot about this topic. Thank you for your patience, and for reminder.

I will contact you.

Permalink Reply by Francesco on October 29, 2018 at 1:55am

I have finally solved on my laptop considering this prompt commands:

Permalink Reply by djordje on October 29, 2018 at 2:16am

Hi Francesco,
These are very nice news!! I am glad it works!
Maybe it didn't work in May, because the permissions have not been set to the MapWinGIS folder, the way we set them up on Friday.

Permalink Reply by Stoyan Yordanov on December 3, 2018 at 2:11pm

Thx for writting this guys it helped out !!!!!!!!!!!!!!!!!!!!!

Permalink Reply by Julian on July 10, 2019 at 5:38pm

Hi djorde,

unfortunately I'm getting the same error message, even after following all the steps mentioned above. I tried now multiple times, but nothing changes. Do you have any other suggestions of what I could try?

Thank you,

Julian

https://storage.ning.com/topology/rest/1.0/file/get/3268900060?prof...

PS: Im working with Rhino 6 on a Win10 (64Bit) Notebook

Permalink Reply by djordje on July 10, 2019 at 9:53pm

Hi Julian,
Can you try following all the steps in this reply:
https://www.grasshopper3d.com/group/gismo/forum/topics/com-class-fa...

Permalink Reply by Julian on July 11, 2019 at 5:08am

Hi Djordje,

thank you for your quick reply. This time it worked out, gismo is up an running!

I already tried these steps multiple times yesterday, however i didn't know that Win10 differentiates between an account with admin rights and a proper admin account. After enabling the admin account, the procedure as mentioned above worked.

Thank you for your help and for making this awesome plugin!