Grasshopper

algorithmic modeling for Rhino

joint component

Hallo all, 

I have problems in using the joint components. I have tried to implement in a simple version of a simple beam as the manual indicates, but I did not managed. 

Could someone help?

Also in the given code I am simulating an outrigger system for a high rise. I want to implement joints between the elements 8,10,7,9 (those are the outriggers) and 6,4,5,3 (those are the tension elements) 

Any suggestions?

Thank you!

Views: 341

Attachments:

Replies to This Discussion

Permalink Reply by Karamba3D on November 28, 2017 at 1:10pm

Dear Popi,

use the 'Beam-Joints'-component to specify hinges - see attached definition and the manual.

Best,

Clemens

Attachments:
Permalink Reply by popi papa on December 4, 2017 at 6:01am

Thank you very much! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service