Grasshopper

algorithmic modeling for Rhino

populate geometry of a surface with its corner point included

Hello,

I am trying to make a Delaunay mesh from a plane, using the populate geometry tool.

I would like to get the corner of each plane to be included in the output mesh, so the surface are continuous between them.

I have found how to get the corner point, but I can't figure out how to use them.

Thank you for any input :)

Views: 1211

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 16, 2017 at 4:49am

Hi.

Check this out.

Attachments:
Permalink Reply by bloap on November 16, 2017 at 5:42am

Hello!

Thank you very much!

How if I want the corners to be part of the movement and the Delaunay mesh, so we don't perceive the limit of each plane.

Should I need to merge and cull the point before sending them to the Delaunay mesh component?

I get strange results...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service