How can I incline contours on a loft progressively?

Replies to This Discussion

Permalink Reply by Joseph Oster on November 6, 2017 at 7:12am

Instead of contours, I used rotated planes.  There are three controls:

1. 'MD Slider' picks a reference point and orientation for the initial plane.
2. 'Domain' slider sets the total angle of rotation.
3. 'Steps' slider divides the angle domain and incrementally rotates the plane.

Finally, 'Sec (Brep | Plane intersection)' returns the curves where the rotated planes intersect the surface.

Attachments:

• GRISDSHELLWIP_2017Nov6a.gh, 51 KB

Permalink Reply by scott on November 6, 2017 at 8:01am

you're a god, thank you very much !

Permalink Reply by Joseph Oster on November 6, 2017 at 8:11am

Hah!  No, not at all.  You're welcome.