Grasshopper

algorithmic modeling for Rhino

Scaling only the wide side of a rectangle

Hello all!

I have problems scaling the rectangles in the wide. At the moment they are scaling

in both directions. I managed them to get scaled in the wide but then they had a diamond shape but I need the rectangle shape. Any suggestions?

Thanks in advance!

Views: 375

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 19, 2017 at 2:31pm

Like this?

Attachments:
Permalink Reply by Lorenz Weiss on October 19, 2017 at 2:56pm
Hey thank you very much!
I can't check it out right now but from the
picture you attached it looks exactly like
that what I was looking for. I will check it
tomorrow.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service