Grasshopper

algorithmic modeling for Rhino

Cluster messing up my geometry

My cluster outputs line segments.

When the cluster is in "edit" mode, the preview of these curves is OK and everything makes sense.

But when the cluster is closed, the result is nuts.

Two segments seem to be merged, and I have a short, silly extra segment in the end of my segment sequence.

Views: 449

Replies to This Discussion

Permalink Reply by Brian Harms on October 9, 2017 at 12:38pm

can you upload all pertinent files?

Permalink Reply by Olivier Suire on October 9, 2017 at 1:34pm

Hi Brian,

here are the files.

The definition requires Human and Fabtools.

Attachments:
Permalink Reply by Olivier Suire on October 9, 2017 at 2:17pm

Permalink Reply by Brian Harms on October 9, 2017 at 2:19pm

Hey Olivier,

Sorry I don't have fabtools, and my tabs are pretty full so I'm not sure I'd want to install another plugin, but it sounds like you got it working?

Also not sure about the difference in previewed results. If you can replicate it with just pure GH (although I have Human installed already) then I can take a look.

Best,

Brian

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service