Grasshopper

algorithmic modeling for Rhino

Copy base curve geometry to many other points

Hi guys,

Is there an easy way to copy a base curve/rectangle from it's centre point to many other points? I have divided a curve into a series of points and set a perp frame at each point. I would like to substitute a rectangle that has been drawn earier to each of these point and align it with the perp frame.

I'm sure there is an easy way, but I can't figure it out!

Thanks

Views: 3653

Replies to This Discussion

Permalink Reply by Michael Pryor on September 28, 2017 at 7:47am

And if it is some random curve you drew, you can use the orient (change basis transformation) by defining a location (point and plane in reference to the curve) and orienting that to the curve frames. 

Attachments:
Permalink Reply by Michael Pryor on September 28, 2017 at 7:48am

If it is just a rectangle (or most other gh created curve primitives as they all have a base plane input) you can just make the rectangle on the frame.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service