Installation problem of the ladybug-honeybee plug-ins

Hi,

Firstly, I had a "grasshopper breakpoint” problem of ladybug-honeybee plugins and I couldn’t use any components. So, I decided to remove and reinstall these couple of programs. But, after then I can’t install them again. As far as I've learned from tutorial videos, I downloaded these plugins, open files but I can’t throw component files into the grasshopper. Grasshopper rejected them. Therefore, this plug-ins could not load. I don't know what caused that. My computer operating system is Windows 10. I wonder if the problem is because version differences. I'd appreciate If you help installing the plug-ins.

Attachments:

Grasshopper breakpoint sorunu.JPG, 3.1 MB
1.jpg, 588 KB
2.jpg, 593 KB

Replies to This Discussion

Permalink Reply by Michael Pryor on September 7, 2017 at 3:13pm

Did you try directly putting them in the folder?

In grasshopper go to File>Special Folders>User Objects Folder. Put them in that folder. Then restart grasshopper with the rhino command "GrasshopperUnloadPlugin" and then launch grasshopper again.

Permalink Reply by Meryem Alagöz on September 8, 2017 at 1:05am

I have just installed programs. Thank you so much Mr. Pryor :) However "grasshopper breakpoint” problem continue again. Is there any solution for this problem?

Attachments:

Grasshopper breakpoint.jpg, 408 KB

Permalink Reply by mısra on November 12, 2018 at 12:02am

how did you solve problem?I have same

Permalink Reply by Meryem Alagöz on May 16, 2018 at 4:45am

Dear all,

I can use the Ladybug smoothly. But honeybee is not flying and gives the warnings in attached file. I suppose I do not have the necessary files, where can I find it if it is missing?

Could you help me please?
Thank you..

Attachments:

honeybee problem.jpg, 273 KB

Permalink Reply by Meryem Alagöz on November 12, 2018 at 4:25am

Hi Mısra;
The problem was the version of the grasshopper. I loaded the new version and went to File>Special Folders>User Objects Folder. And the file which included the files ladybug-honeybee put them in that folder. Then restart grasshopper and wrote "GrasshopperUnloadPlugin" and then launched grasshopper again.
That's all..

RSS